Warranty

Forrester Manufacturing Co., Inc. warrants the Duck Commander Wake Maker motorized decoy system to be free of defects in materials and workmanship for 1 year from the date of purchase. Please call customer service at Toll Free 866-256-4499 for instructions on warranty claims or parts replacement. Please do not contact the retailer from which you purchased your system.

The following components are included in your Duck Commander
Wake Maker Automated Motorized Decoy System.

The programmable remote controller can be used from the convenience of your blind. With it, you can turn the system on or off and easily control the swim speed and travel distance of your decoys. Calibration only takes a couple of minutes and once set, will repeat the same motion indefinitely (the only time you must recalibrate is when the system is disconnected from the 12V power source). This enables your system to be hands free.
The motor assembly is completely sealed and designed to work silently while submerged below water level. It comes with the drive pulley, pole attachment and 30' lead preassembled for ease of installation.
Your Duck Commander Wake Maker™ system comes with a set of three (3) mounting poles. Total overall length from tip to tip is 40". Length from crossbar to top is 27". This allows the system to operate easily in water as shallow as 6" to as deep as 30".
The towline is approximately 150' long and when installed around the idler pulleys, the motor defines the perimeter of the system. It has snap swivels on each end of the line to connect to the bridle and to make a complete loop. It also has a snap swivel spaced evenly on the line to attach the decoy tethers.
The bridle is used to attach 2 decoys side by side for a more realistic swim formation. The short arm has each end of the towline attached to complete the loop, while the long arm is used to attach the decoys. It also spaces the decoys far enough apart to prevent them from touching each other as the system reverses the swim direction.
The idler pulleys each attach to a pole with a thumbscrew and allow the towline to move freely. The 2 vinyl sleeves slide down over the steel pins to secure the towline during installation.
The Wake Maker™ system includes 6 tethers with snap swivels on one end that attach to a corresponding snap swivel on the towline. The bare end is to be tied to the keel of the decoy (not included).
The 2 marine terminals included will fit on a top post battery (not included) and has a screw-on post to attach the programmer.